   
Laser Pro Park Single Head - £295
Front or Rear Protection
(Supply only)
Laser Park Pro Dual Head
- £495
Front and Rear Protection
(Supply only)
Contact us
to order or discuss installation options
Installation is custom to each vehicle
depending on location and available space to mount laser heads.
Installation will be quoted on after reviewing your requirements. |
About the Laser Pro Park
The Laser Pro is the only device on the
market to use such high quality lasers and lenses giving huge
advantages to both reception and coverage. The unit is supplied with a
single laser sensor which can
be fitted to either the front or the
rear of the vehicle, additional laser sensor heads are available which
plug in to the same junction box.
The unit uses the licence
free 904nm laser frequency. The same frequency as used by several
motor
manufacturers eg. Nissans adaptive cruise control system which
uses laser to determine the distance
immediately in front of the
vehicle and to deactivate the cruise control if the stopping distance
is considered
to be too short. Police laser guns use the same 904 nm
frequency also.
In order to prevent interference with other
laser based systems the Laser Pro Park has been designed to
alert the
driver of possible interference & switch the system down after a set
time.
Should new laser frequencies be allocated by the Home
Office then the unit can be upgraded in the field
using the USB port
in the junction box. We believe the Laser Pro Park will increase your
driving pleasure
and keep you and your vehicle safe from unnecessary
damage for many years to come.
Specifications
|
Switching On/off: |
| ON / OFF switch on
the wiring loom |
|
Duration of self
diagnostic: |
| 1 sec during every
activation (red and green LED light up and speaker sounds) |
|
Indication of
functionality: |
| Blinking of green
Bi colour LED every 1 sec or the bleeping of the parking sensor
should an object be within 5 metres depending on the
reflectivity of the object. |
|
Operation: |
Start mode -
first few seconds after activation - self diagnostic
Search mode - lasts until detection of LIDAR laser beam
Alert mode - upon detection of laser signal reflected from
own laser sensor or in the unlikely event of other laser based
systems using the 904nm frequency in close proximity.
Loudness of warning sound: 85dB
Wavelength: 904 nm
Laser class: Class 1M
Extreme caution: The Laser Sensor emits invisible laser
radiation which may be harmful to the human eye. Please take
particular caution when fitting the unit. Under no circumstances
should you look directly at the device whilst the unit is
switched on or connected to a live power supply.
The system must not be relied upon entirely when parking your
vehicle as there can be no substitute for good judgment. The
manufacturer cannot be held responsible for system malfunction
and any consequential damage |
Frequently Asked Questions
Does the unit use frequencies which are allowed in the UK?
Yes, the system uses the licence free 904nm and although
interference with other equipment cannot be ruled out, in the
unlikely event of other laser based systems working in close
proximity, the system has been designed to switch itself off. The
system can be used for the purpose it was developed and should not
be used for other purposes.
Which reflective surfaces provide better
detection distances?
The brighter the surface the further the distance the Laser Pro Park
will detect up to 3 metres away. Parking in ones own garage for
example we recommend you test with different material in front of
the vehicle.
Can the Laser Pro Park cause damage to the
human eye?
The unit is a Class 1 laser and is therefore low power & safe but we
recommend you do not look into the lens of the unit at any time The
Junction Box has 2 inputs does it make any difference which port I
connect the laser Sensor to and subsequently can I buy an additional
sensor for the rear of the vehicle?
Plug in to any of the two ports and yes additional Laser Sensor
Heads are available
The lens on the front of the unit has been
damaged can it be replaced?
Yes. We suggest you disconnect the Laser Sensor head from the the
Junction Box and contact Comtech details below to arrange to have
the product returned for repair. Alternatively contact Comtech to
purchase a replacement lens and fit this yourself.
How do I test the unit and can it be
triggered by a TV remote control?
No a TV remote control will not trigger the system. The unit has
been designed to prevent unnecessary false alerts. The system
performs a self check on power up two audible beeps followed by
flashing green LED.
Place a piece of paper over the lens and this should trigger the
device into alert.
The unit has stopped working and doesn't go
through the start up procedure, what should I do?
Check the ON / OFF switch has not been switched to OFF. Check the
mute button has not been pressed. Locate the Junction box and check
the 1A fuse inside the Junction box has not blown.
Examples:-
Lower Grill installation
  
Sounder, switches and led (stealthy)
installation
  
Grill & Rear installation
  
|
